DC Physics logo

HOME


space

 

 

Oobleck and Glurch - Physics Fun at Home

September 2001

The start of another school year seems a good time to mention one of my favorite educational toys -- non-newtonian fluids. The most common of these is "Silly Putty", however there are a variety of solutions you can make up at home with the property that how "solid" they are depends on how hard you are pushing on them.

These materials are not only a good discussion source for kids, you can make up games to get them experimenting with the properties. For example, see who can stretch their glurch out into the longest strand in a minute. (Note: kids will likely call the glurch "flubber".) Or, see who can come up with the fastest way to get oobleck from one container to another. Pouring is slow, but when you try to spoon it out it becomes a matter of chiseling. Its fun to watch the solid chunks turn back to a liquid on the spoon, then back to a solid as they go back under tension when they start to drip down.

These materials also make great slimes etc for Halloween. Put some green food coloring in your glurch and stick some blobs of it around where it can slowly drip down into disgusting appearances. My favorite effect is to stretch it out flat and use it for a "lid" to a cup, then see what happens over the next few minutes.

Here are some other sources for recipes and ideas for educational plans using such materials.

Return to DC Physics

 

Standard Oobleck

Oobleck is not a precise recipe - it is basically a thick solution of water and corn starch - with food coloring to suite yourself. Put together roughly equal amounts of each. If you can stir it, add more corn starch. The thicker the solution the harder it will become to stir the solution together. You may have to leave it to soak together. Pick it up in the spoon and you'll have chunks, but as the tension releases you'll see them go back to liquid.

Standard Glurch

Solution #1
a 3:4 mixture of white glue and water (e.g. 3/4 cup of white glue to one cup of water)

Solution #2
Saturated water/borax. Add enough borax that it won't dissolve any more. This is approximately 3 tablespoons of Borax to 1 cup of water.

Directions
Add some food coloring (for effect only, not required to make the glurch work) to one of the two solutions then mix 3:1 of the first solution to the second. For example, 6 tablespoons of #1 to 2 tablespoons of #2. Stir together quickly or you may get an very dense blob in the middle. Stir/knead the glurch until it is of a uniform consistency. Or, since 3 tsp = 1 tbsp, use tablespoons to measure #1 and the same number of teaspoons to measure #2.

DC Physics Home Page | More DC Physics Notes